NonStop Operating System Event Management Programming Manual

Labeled-Tape Server Events Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
9-25
Messages
Unconditional Tokens
Conditional Tokens
Cause. A BLP request was made for a specific device. There is a BLPCKECK for the
tape device, as shown in the MEDIACOM INFO TAPEDRIVE command.
Effect. The requesting application is suspended until you accept or reject the request.
Recovery. The request is suspended as a outstanding request until one of the
following actions is taken:
Message sender: $ZSVR
TMDS collector: No
OSM/TSM collector: No
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-ACTION-ID token-type ZSPI-TYP-INT
ZEMS-TKN-TEXT token-type ZSPI-TYP-STRING
ZTAP-TKN-DEV-NAME token-type ZSPI-TYP-DEVICE
Conditional Tokens
ZEMS-TKN-TEXT token-type ZSPI-TYP-STRING
Event-Message Text
$ZSVR: seq REQUEST TO USE $dev WITH NO LABEL PROTECTION
[ comment ]
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-
REQBLP (607).
ZEMS-TKN-ACTION-ID $ZSVR internal message number that identifies the
request. This token contains a four-digit number ranging
from 0000 through 9999.
ZEMS-TKN-TEXT Standard EMS token that contains the message text. See
Event Management Service (EMS) Standard Definitions
on
page 9-9.
ZTAP-TKN-DEV-NAME Subject token that specifies the device name.
Token Description
ZEMS-TKN-TEXT Up to 80 bytes of comments that were specified with the
DEFINE attribute MOUNTMSG. These comments provide
information for the operator such as the relative length and
urgency of the job.