NonStop Operating System Event Management Programming Manual

Labeled-Tape Server Events Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
9-34
Messages
Recovery. To use the tape, run TAPECOM SCRATCH or MEDIACOM
ADDTAPELABEL SCRATCH to make the volume a scratch tape; then repeat the
operation that caused the error.
614: ZTAP-EVT-WRONGTAPEERR
A tape device was expecting a specific continuation volume.
Unconditional Tokens
Cause. The mounted tape volume is not the required tape volume (which is a
continuation volume for a multivolume operation).
Effect. The system unloads the tape, and the requesting application is suspended
until the correct tape is mounted.
Subject: ZTAP-TKN-DEV-NAME
Potentially critical event: No
Action event: No
Message sender: $ZSVR
TMDS collector: No
OSM/TSM collector: No
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-TEXT token-type ZSPI-TYP-STRING
ZTAP-TKN-DEV-NAME token-type ZSPI-TYP-DEVICE
ZTAP-TKN-ERRMSGNUMBER token-type ZSPI-TYP-UINT
ZTAP-TKN-ERRTAPEVOLUME token-type ZTAP-TYP-TAPE-VOLUME
ZTAP-TKN-TAPE-VOLUME token-type ZTAP-TYP-TAPE-VOLUME
Event-Message Text
ERROR 3 - WRONG TAPE, vid MOUNTED, SHOULD BE vid
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-
WRONGTAPEERR (614).
ZEMS-TKN-TEXT Standard EMS token that contains the message text. See
Event Management Service (EMS) Standard Definitions
on page 9-9.
ZTAP-TKN-DEV-NAME Subject token that specifies the device name.
ZTAP-TKN-ERRMSGNUMBER Labeled-tape defined error number (3).
ZTAP-TKN-ERRTAPEVOLUME Volume serial number of the volume in error.
ZTAP-TKN-TAPE-VOLUME Subject token that specifies the volume serial number of
the correct volume to use.