NonStop Operating System Event Management Programming Manual

Labeled-Tape Server Events Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
9-42
Messages
622: ZTAP-EVT-USEBACKUPTAPEERR
A volume was mounted to satisfy a backup request, but the volume had an IBM label.
Unconditional Tokens
Cause. The mounted tape volume is an IBM labeled tape. Use a BACKUP labeled
tape or an ANSI labeled tape instead.
Effect. The system unloads the tape, and the requesting application is suspended
until the correct type of tape is mounted.
Recovery. If the operation is for output, label a new tape with the correct type and
mount this tape; then retry the operation. (An ANSI tape can be used for BACKUP.)
Subject: ZTAP-TKN-DEV-NAME
Potentially critical event: No
Action event: No
Message sender: $ZSVR
TMDS collector: No
OSM/TSM collector: No
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-TEXT token-type ZSPI-TYP-STRING
ZTAP-TKN-DEV-NAME token-type ZSPI-TYP-DEVICE
ZTAP-TKN-ERRMSGNUMBER token-type ZSPI-TYP-UINT
ZTAP-TKN-ERRTAPEVOLUME token-type ZTAP-TYP-TAPE-VOLUME.
Event-Message Text
ERROR 11 - VOLUME vid IS IBM TAPE, NOT BACKUP TAPE AS
REQUESTED
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-
USEBACKUPTAPEERR (622).
ZEMS-TKN-TEXT Standard EMS token that contains the message text. See
Event Management Service (EMS) Standard Definitions
on page 9-9.
ZTAP-TKN-DEV-NAME Subject token that specifies the device name.
ZTAP-TKN-ERRMSGNUMBER Labeled-tape defined error number (11).
ZTAP-TKN-ERRTAPEVOLUME Volume serial number of the mounted tape.