NonStop Operating System Event Management Programming Manual

Labeled-Tape Server Events Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
9-55
Messages
636: ZTAP-EVT-TAPECOMREJECT
The operator used MEDIACOM used to reject a mount or device request.
Unconditional Tokens
Cause. The operator used MEDIACOM or TAPECOM command to reject a mount or
device request.
Effect. The requesting application receives file-system error 194.
Recovery. If the mount request was for a continuation volume of a multivolume
operation, the requesting application must be stopped by the operator. Otherwise, this
is an informational message, and no corrective action is needed.
Subject: ZTAP-TKN-PROCESS
Potentially critical event: No
Action event: No
Message sender: $ZSVR
TMDS collector: No
OSM/TSM collector: No
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-TEXT token-type ZSPI-TYP-STRING
ZTAP-TKN-PROCESS token-type ZSPI-TYP-CRTPID
ZTAP-TKN-STSMSGNUMBER token-type ZSPI-TYP-UINT
ZTAP-TKN-MSGNUMBER token-type ZSPI-TYP-UINT
Event-Message Text
STATUS 1502 - EXECUTED MEDIACOM REJECT seq
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-
TAPECOMREJECT (636).
ZEMS-TKN-TEXT Standard EMS token that contains the message text. See
Event Management Service (EMS) Standard Definitions
on page 9-9.
ZTAP-TKN-PROCESS Subject token that specifies the process ID of $ZSVR.
ZTAP-TKN-STSMSGNUMBER $ZSVR status message number (1502).
ZTAP-TKN-MSGNUMBER $ZSVR internal message number that identifies the
request. This token contains a four-digit number ranging
from 0000 through 9999.