NonStop Operating System Event Management Programming Manual

Labeled-Tape Server Events Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
9-71
Messages
652: ZTAP-EVT-ACCEPTDEVICE
This action-completion message indicates that was accepted by the operator a request
for a tape device from an earlier action-attention event message.
Unconditional Tokens
Cause. A request for a tape device from an earlier action-attention event message
was accepted by the operator.
Effect. This event message informs an application that the action-attention event
indicated by ZEMS-TKN-ACTION-ID has been completed.
Recovery. This is an informational message only; no corrective action is needed.
Subject: ZTAP-TKN-DEV-NAME
Potentially critical event: No
Action event: No
Message sender: $ZSVR
TMDS collector: No
OSM/TSM collector: No
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-ACTION-NEEDED token-type ZSPI-TYP-BOOLEAN
ZEMS-TKN-ACTION-ID token-type ZSPI-TYP-INT
ZTAP-TKN-DEV-NAME token-type ZPSI-TYP-DEVICE
Event-Message Text
$ZSVR: seq REQUEST FOR DEVICE dev ACCEPTED BY OPERATOR
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-
ACCEPTDEVICE (652).
ZEMS-TKN-ACTION-NEEDED Has the value ZSPI-VAL-FALSE.
ZEMS-TKN-ACTION-ID $ZSVR internal message number that identifies the
request. This token contains a four-digit number ranging
from 0000 through 9999.
ZTAP-TKN-DEV-NAME Subject token that specifies the name of the device that
was accepted.