NonStop Operating System Event Management Programming Manual

Labeled-Tape Server Events Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
9-104
Messages
684: ZTAP-EVT-SSINOAVR
A tape successfully mounted in an ACS was not being detected by the tape drive.
Unconditional Tokens
Cause. A tape successfully mounted in an ACS was not being detected by the tape
drive. The possible reasons for this error are:

The tape drive is offline.

There is a problem with the data path connection.

The LSM address assigned to the tape drive (using the MEDIACOM ALTER
TAPEDRIVE command) is the address of a different tape drive.
Subject: ZTAP-TKN-PROCESS
Potentially critical event: No
Action event: No
Message sender: $ZSVR
TMDS collector: No
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-ACTION-NEEDED token-type ZSPI-TYP-BOOLEAN
ZEMS-TKN-ACTION-ID token-type ZSPI-TYP-INT
ZTAP-TKN-PROCESS token-type ZSPI-TYP-CRTPID
ZTAP-TKN-ERRMSGNUMBER token-type ZSPI-TYP-UINT
ZTAP-TKN-TAPE-VOLUME token-type ZTAP-TYP-TAPE-VOLUME
ZTAP-TKN-DEV-NAME token-type ZTAP-TYP-DEVICE
Event-Message Text
ERROR 1026 - NO MOUNT SEEN FOR volser ON device
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-
CMSSINOAVR (684).
ZEMS-TKN-ACTION-NEEDED Has the value ZSPI-VAL-FALSE.
ZEMS-TKN-ACTION-ID $ZSVR internal message number that identifies the
request. This token contains a four-digit number ranging
from 0000 through 9999.
ZTAP-TKN-PROCESS Subject token that specifies the process for this event.
ZTAP-TKN-ERRMSGNUMBER Labeled-tape defined error number (1026).
ZTAP-TKN-TAPE-VOLUME Subject token that specifies the volume serial number of
the correct volume to use.
ZTAP-TKN-DEV-NAME Subject token that specifies the device name.