NonStop Operating System Event Management Programming Manual

Labeled-Tape Server Events Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
9-107
Messages
Recovery. Connection to the tape drive is retried automatically as follows:

If the processor is down, reload the primary processor or backup processor of the
device.

If the processor is not down, perform a MEDIACOM STATUS TAPEDRIVE device
command on the tape drive.

Stop the primary $ZSVR process.
If the error continues to occur, see Recovery Action Requiring Vendor Support on
page 9-12.
687: ZTAP-EVT-LINKUP
A connection to a tape drive was reestablished.
Unconditional Tokens
Cause. A connection to a tape drive was reestablished.
Effect. The tape drive can be used for labeled-tape processing.
Recovery. This is an informational message only; no corrective action is needed.
Subject: ZTAP-TKN-PROCESS
Potentially critical event: No
Action event: No
Message sender: $ZSVR
TMDS collector: No
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-ACTION-NEEDED token-type ZSPI-TYP-BOOLEAN
ZEMS-TKN-ACTION-ID token-type ZSPI-TYP-INT
ZTAP-TKN-PROCESS token-type ZSPI-TYP-CRTPID
Event-Message Text
STATUS 1514 - CONNECTION TO device COMPLETED SUCCESSFULLY
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-
LINKUP (687).
ZEMS-TKN-ACTION-NEEDED Has the value ZSPI-VAL-FALSE.
ZEMS-TKN-ACTION-ID $ZSVR internal message number that identifies the
request. This token contains a four-digit number ranging
from 0000 through 9999.
ZTAP-TKN-PROCESS Subject token that specifies the process for this event.