NonStop Operating System Event Management Programming Manual

Labeled-Tape Server Events Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
9-114
Messages
Cause. The TPTM disallowed a tape operation because of a file-system error, but the
operation could not be stopped at this point.
Effect. The tape operation continues.
Recovery. This is an informational message only; no corrective action is needed.
695: ZTAP-EVT-MEDIAMISMATCH
The requested and actual tape density or tape mode did not match.
Unconditional Tokens
ZEMS-TKN-ACTION-ID $ZSVR internal message number that identifies the
request. This token contains a four-digit number ranging
from 0000 through 9999.
ZTAP-TKN-PROCESS Subject token that specifies the process for this event.
ZTAP-TKN-ERRMSGNUMBER Labeled-tape defined error number (1034).
ZTAP-TKN-FSERR File-system error number received.
Subject: ZTAP-TKN-PROCESS
Potentially critical event: No
Action event: No
Message sender: $ZSVR
TMDS collector: No
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-ACTION-NEEDED token-type ZSPI-TYP-BOOLEAN
ZEMS-TKN-ACTION-ID token-type ZSPI-TYP-INT
ZTAP-TKN-WRNMSGNUMBER token-type ZSPI-TYP-UINT
ZTAP-TKN-TAPE-VOLUME token-type ZTAP-TYP-TAPE-VOLUME
ZTAP-TKN-DEV-NAME token-type ZSPI-TYP-DEVICE
Event-Message Text
WARNING 909 - volser ON device DOES NOT ALLOW REQUESTED
DENSITY/TAPEMODE
Token Description (page1of2)
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-
MEDIAMISMATCH (695).
ZEMS-TKN-ACTION-NEEDED Has the value ZSPI-VAL-FALSE.
ZEMS-TKN-ACTION-ID $ZSVR internal message number that identifies the
request. This token contains a four-digit number ranging
from 0000 through 9999.
Token Description (page 2 of 2)