NonStop Operating System Event Management Programming Manual

Labeled-Tape Server Events Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
9-115
Messages
Cause. The requested and actual tape density or tape mode did not match. The
requested tape volume is not mounted on the tape drive that does not support the
requested DENSITY/TAPEMODE. $ZSVR selects only tape drives that are support the
requested DENSITY/TAPEMODE.
Effect. The mount request is unsatisfied and the operator would not know why the
specified tape was not used.
Recovery. Reject the request and correct the DEFINE to either specify
DENSITY/TAPEMODE or specify the correct DENSITY/TAPEMODE, and retry the
operation. Note that if DSM/TAPE CATALOG is not being used (via CLASS
TAPECATALOG DEFINEs), the tape volumes are automatically selected to match the
specified DENSITY or TAPEMODE.
696: ZTAP-EVT-SSINOTAPE
There was no tape in the ACS.
ZTAP-TKN-
WRNMSGNUMBER
$ZSVR warning message number (909).
ZTAP-TKN-TAPE-VOLUME Subject token that specifies the volume serial number of
the correct volume to use.
ZTAP-TKN-DEV-NAME Subject token that specifies the device name.
Subject: ZTAP-TKN-DEV-NAME
Potentially critical event: No
Action event: No
Message sender: $ZSVR
TMDS collector: No
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-ACTION-NEEDED token-type ZSPI-TYP-BOOLEAN
ZEMS-TKN-ACTION-ID token-type ZSPI-TYP-INT
ZTAP-TKN-DEV-NAME token-type ZSPI-TYP-DEVICE
ZTAP-TKN-ERRMSGNUMBER token-type ZSPI-TYP-UINT
ZTAP-TKN-DEFINE-NAME token-type ZTAP-TYP-DEFINE-NAME
Event-Message Text
ERROR 1035 - NO TAPE FOUND IN CORRECT ACS FOR device, WILL
RETRY
Token Description (page2of2)