NonStop Operating System Event Management Programming Manual

Labeled-Tape Server Events Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
9-127
Messages
Unconditional Tokens
Conditional Tokens
Cause. A tape file was opened for input for ESM processing, but the tape was not
mounted.
Effect. The operation waits for the tape with the requested ESM volser to be mounted
(on drive, if specified).
Recovery. Either mount the specified tape (on drive, if specified) with write
protection or reject the request using the MEDIACOM REJECT TAPEMOUNT
command.
Event-Message Text
MOUNT ESM volser [REEL reel] [DENSITY density] [ON drive]
NO RING ALIAS = alias
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-
MTESMIN (706).
ZEMS-TKN-ACTION-ID $ZSVR internal message number that identifies the
request. This token contains a four-digit number ranging
from 0000 through 9999.
ZEMS-TKN-TEXT Standard EMS token that contains the message text.
See Event Management Service (EMS) Standard
Definitions on page 9-9.
ZTAP-TKN-TAPE-VOLUME Subject token that specifies the serial number of the
requested volume.
Token Description
ZTAP-TKN-REEL Reel number, if this operation is a multivolume operation.
ZTAP-TKN-DENSITY Tape density. Values are ZSPI-VAL-800BPI, ZSPI-VAL-
1600BPI, and ZSPI-VAL-6250BPI.
ZTAP-TKN-DEV-NAME Subject token that specifies the tape drive device name
in the system. This token is present if the request is for a
continuation volume of a multivolume operation or if the
user requested a specific device.
ZEMS-TKN-TEXT Up to 80 bytes of comments that were specified with the
DEFINE attribute MOUNTMSG. These comments
provide information for the operator such as the relative
length and urgency of the job.