NonStop Operating System Event Management Programming Manual

HP NonStop Operating System Event Management Programming Manual—520372-020
10-1
10 Tape Process Event Messages
(ZTAP)
Tape process event messages are reported to the EMS only by the tape process.
Table 10-1. Tape Process Event Messages (page 1 of 7)
Event Number and Symbolic Name Description
-1032: ZTAP-EVT-DEV-RESET
A tape drive has been reset by its
controller.
-1031: ZTAP-EVT-DEV-IF-ERROR
An error occurred between a tape
drive controller and a tape drive.
-1030: ZTAP-EVT-DEV-SCSI-STATUS
A tape drive reported a SCSI status.
-1029: ZTAP-EVT-DEV-BUSY
A tape drive reported an incomplete
command.
-1028: ZTAP-EVT-DEV-CMD-INCOMP
A tape drive reported an incomplete
command.
-1027: ZTAP-EVT-DEV-CMD-TIMEOUT
A command sent to a tape drive timed
out.
-1026: ZTAP-EVT-DEV-SEL-TIMEOUT
A tape drive selection operation timed
out.
-1025: ZTAP-EVT-CTLR-DOWNLOADED-CMN
A servernet addressable controller
(SAC) has been downloaded.
-1024: ZTAP-EVT-STRUCTURED-XSUM-CMN
A tape drive reported a structured
checksum error.
-1023: ZTAP-EVT-SECTOR-XSUM
A tape drive reported a sector
checksum error.
-1022: ZTAP-EVT-UNEXPECTED-INT-CMN
An unexpected interrupt has been
detected.
-1021: ZTAP-EVT-INT-TIMEOUT-CMN
An interrupt timeout has been
detected.
-1020: ZTAP-EVT-PON-CMN
A power-on (PON) interrupt occurred.
-1019: ZTAP-EVT-ERROR-INJECTION
An error was injected by an external
program.
-1018: ZTAP-EVT-TIMEOUTS-EXCEEDED-CMN
The number of timeouts allocated for
an operation was exceeded.
-1017: ZTAP-EVT-PATH-SWITCH-CMN
A tape drive reported a path switch.
-1016: ZTAP-EVT-PATH-STATE-CHANGE
The state of a path has changed to a
new state.
-1015: ZTAP-EVT-CPU-SWITCH-CMN
An I/O process was switched to
another processor.