NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-2
-1014: ZTAP-EVT-RECOVERY-COMPLETION A sense key reported an error
recovery.
-1013: ZTAP-EVT-SK-MISCOMPARE
A sense key reported that source data
did not match read data.
-1012: ZTAP-EVT-SK-VOL-OVFLOW
A sense key reported that end-of-
partition and unwritten data was left in
a buffer.
-1011: ZTAP-EVT-SK-EQUAL
A sense key reported that SEARCH
DATA has found an equal
comparison.
-1010: ZTAP-EVT-SK-ABORTED-CMND
A sense key reported that a command
was aborted.
-1009: ZTAP-EVT-SK-COPY-ABORT
A sense key reported that a copy
operation was aborted.
-1008: ZTAP-EVT-SK-VENDOR-SPECIFIC
A sense key reported a vendor-
specific error.
-1007: ZTAP-EVT-SK-BLANK-CHK
A sense key reported that a blank
check for a read operation was
returned.
-1006: ZTAP-EVT-SK-DATA-PRTCT
A sense key reported that a tape is
write protected.
-1005: ZTAP-EVT-SK-UNIT-ATTENTION
A sense key reported a unit attention
request.
-1004: ZTAP-EVT-SK-ILLEGAL-REQ
A sense key reported an illegal
request.
-1003: ZTAP-EVT-SK-HW-ERR
A sense key reported a hardware
error.
-1002: ZTAP-EVT-SK-MEDIUM-ERR
A sense key reported a damaged
tape.
-1001: ZTAP-EVT-SK-NOT-RDY
A sense key reported that a drive is
not ready.
-1000: ZTAP-EVT-SK-RECVRD-ERR
A sense key reported an error
recovery.
32: ZTAP-EVT-SYN-SEC-XSUM-ERR
A sector checksum error occurred.
33: ZTAP-EVT-SYN-BLK-XSUM-ERR
A block checksum error occurred.
64: ZTAP-EVT-SYN-FN-CODE-INV
An MDR function code is invalid.
65: ZTAP-EVT-SYN-MDR-FLD-CONT-ERR
An MDR field content error occurred.
66: ZTAP-EVT-SYN-CTRL-LOC-RQD
A controller lock is required.
96: ZTAP-EVT-SYN-MD-INT-ERR
A module driver interface error
occurred.
Table 10-1. Tape Process Event Messages (page 2 of 7)
Event Number and Symbolic Name Description