NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-4
194: ZTAP-EVT-SYN-DEV-CMD-INCOMP A tape drive was performing another
action when another command was
received.
195: ZTAP-EVT-SYN-DEV-BUSY
A tape drive was performing another
operation when another command
was received.
196: ZTAP-EVT-SYN-SCSI-STATUS
A command was incomplete.
197: ZTAP-EVT-SYN-DEV-INTF-ERR
An error occurred between a tape
drive and a controller.
198: ZTAP-EVT-SYN-DEV-RESET
A tape drive was reset.
199: ZTAP-EVT-SYN-DATA-OVERRUN
A tape device requested more data
than the I/O process sent.
200: ZTAP-EVT-BAD-UCODE
The microcode is incorrect.
201: ZTAP-EVT-CHANNEL-DMA-ERROR
A channel or controller DMA error
occurred.
202: ZTAP-EVT-CHANNEL-ERROR
A channel error occurred.
203: ZTAP-EVT-FORMATTER-PWR-OFF
The formatter is powered off.
204: ZTAP-EVT-HARD-CNTLR-ERROR
A hard controller error occurred.
205: ZTAP-EVT-HARD-SELFTEST-ERROR
A hard self-test error occurred.
206: ZTAP-EVT-ILLEGAL-COMMAND
An illegal command was sent to a
controller.
207: ZTAP-EVT-NVRAM-XSUM
A checksum error occurred on
NVRAM.
208: ZTAP-EVT-NVRAM-1000
An NVRAM was written more than
1000 times.
209: ZTAP-EVT-SOFT-SELFTEST-ERROR
A soft self-test error occurred on a
controller.
256: ZTAP-EVT-SYN-CTRL-DISABLED
A controller was disabled.
257: ZTAP-EVT-SYN-CTLR-ACC-NOT-ESTB
Controller access from a processor
could not be established.
258: ZTAP-EVT-SYN-CTRL-UNLOADED
A controller was unloaded.
259: ZTAP-EVT-SYN-CTRL-QUEUE-ACTIVE
An operation or driver module call that
must not be executed while a
controller request queue is active has
been executed.
260: ZTAP-EVT-SYN-CTRL-QUEUE-ERROR
A controller request queue is not
synchronized with a processor.
261: ZTAP-EVT-SYN-CTRL-SHUT-DOWN
A controller request queue is not
synchronized with a processor.
Table 10-1. Tape Process Event Messages (page 4 of 7)
Event Number and Symbolic Name Description