NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-5
288: ZTAP-EVT-SYN-SCSI-BUS-RESET A SCSI-bus reset was issued by a
controller.
289: ZTAP-EVT-SYN-SCSI-BUS-IN
A SCSI-bus reset was initiated by
some external cause, not by a
controller.
300: ZTAP-EVT-DATA-CORRECTED
A correctable data error occurred.
301: ZTAP-EVT-DATA-UNCORRECTED
An uncorrectable data error occurred.
302: ZTAP-EVT-D-PATH-PARITY-ERROR
A data-path parity error occurred.
303: ZTAP-EVT-DRIVE-PWR-OFF
A tape drive was powered off.
304: ZTAP-EVT-ERASE-FAILED
An erase command failed.
305: ZTAP-EVT-FORMATTER-REJECT
A 3206 controller formatter command
was rejected.
306: ZTAP-EVT-FTM-DMA-ERROR
A formatter or DMA error occurred.
307: ZTAP-EVT-FTM-ERROR
A formatter or formatter module error
occurred.
308: ZTAP-EVT-ILLEGAL-DRIVE-STATUS
An illegal drive status was detected.
309: ZTAP-EVT-LARGE-READ
The amount of data to read was too
large for a 3206 controller formatter
buffer.
310: ZTAP-EVT-OPERATION-FAILED
An operation failed.
311: ZTAP-EVT-RUNAWAY-TAPE
A runaway tape occurred.
312: ZTAP-EVT-SHORT-WRITE
A short write (fewer than 24 bytes)
occurred.
313: ZTAP-EVT-SOFT-FTM-ERROR
A soft formatter error occurred.
314: ZTAP-EVT-TERMSTAT-UNKNOWN
An unknown TERMSTAT value was
returned.
315: ZTAP-EVT-WRITE-FAILED
A write operation failed.
316: ZTAP-EVT-CABLE-OPEN
A cable is not connected or is broken.
317: ZTAP-EVT-CONTROLLER-DATA-ERROR
A controller data error occurred.
318: ZTAP-EVT-PHYSICAL-EOT
The physical end of tape (EOT) was
encountered.
319: ZTAP-EVT-DEVICE-INTF-ERROR
A communication error occurred
between a 3209 controller and a 5120
tape drive.
320: ZTAP-EVT-3202-BAD-STATUS
A 3202 controller or a device attached
to it is malfunctioning.
321: ZTAP-EVT-3202-RUNAWAY-TAPE
A 3202 controller indicated a runaway
tape.
Table 10-1. Tape Process Event Messages (page 5 of 7)
Event Number and Symbolic Name Description