NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-6
322: ZTAP-EVT-3202-UNUSUAL-END A 3202 controller indicated an
unusual end.
323: ZTAP-EVT-3202-COMMAND-REJECT
A 3202 controller rejected a
command.
324: ZTAP-EVT-3202-OVERRUN
A 3202 controller detected an overrun
condition.
325: ZTAP-EVT-3202-PARITY-ERROR
A 3202 controller detected a parity
error.
326: ZTAP-EVT-3202-CRCERROR
A 3202 controller detected a CRC
error.
327: ZTAP-EVT-COVER-OPEN
The cover on a tape drive was left
open.
329: ZTAP-EVT-DEVICE-NOT-RESPONDING
The device does not respond.
330: ZTAP-EVT-EQUIP-CHECK
A tape drive problem must be
checked.
331: ZTAP-EVT-ID-BURST-ERROR
A tape problem exists.
332: ZTAP-EVT-SOFT-CNTLR-ERROR
A soft controller error occurred.
333: ZTAP-EVT-UNKNOWN-ERROR
An unknown controller error occurred.
334: ZTAP-EVT-WRITE-ENABLED-ERR
A tape write was attempted with write
ring missing.
335: ZTAP-EVT-DEV-ASSGN-ELSEWHERE
A tape drive is assigned to another
controller.
336: ZTAP-EVT-VOL-FENCED
A tape is incompatible with the tape
drive on which it has been mounted.
337: ZTAP-EVT-INV-MEDIA-FORMAT
A tape is incompatible with the tape
drive on which it has been mounted.
400: ZTAP-EVT-CPU-SWITCH
A processor switch occurred.
401: ZTAP-EVT-EIO-BAD
An EIO instruction returned an invalid
status.
402: ZTAP-EVT-IIO-BAD
An IIO instruction returned an invalid
status.
403: ZTAP-EVT-INT-OVERRUN
A unit-interrupt overrun occurred.
404: ZTAP-EVT-INT-TIMEOUT
An interrupt timed out.
405: ZTAP-EVT-LOAD-UCODE
The loadable control store microcode
of a downloadable controller was
loaded.
406: ZTAP-EVT-PATH-STATE
A path state changed.
407: ZTAP-EVT-PON
A power-on (PON) interrupt occurred.
Table 10-1. Tape Process Event Messages (page 6 of 7)
Event Number and Symbolic Name Description