NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-16
Messages
Unconditional Tokens
Cause. The tape drive was reset by a controller because a command from the
controller to the tape drive aborted.
Effect. The command fails.
Recovery. The reset causes the command to be retried. If the error continues to
occur, see Recovery Action Requiring Vendor Support on page 10-15.
-1031: ZTAP-EVT-DEV-IF-ERROR
An error occurred between a tape drive controller and a tape drive
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-ENUM
ZEMS-TKN-XLDEVNAME token-type ZSPI-TYP-STRING
ZEMS-TKN-LDEVNUMBER token-type ZSPI-TYP-INT2
Event-Message Text
$tapenn Device reset, LDEV $nn
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-DEV-
RESET (-1032).
ZEMS-TKN-XLDEVNAME Subject token that specifies the name of the tape device in
the form $nnnn.
ZEMS-TKN-LDEVNUMBER Subject token that specifies the logical device number in
the form $nn.
Subject: ZTAP-TKN-LDEVNUMBER
Potentially critical event: No
Action event: Yes
Message sender: Tape process
OSM/TSM collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-ENUM
ZEMS-TKN-XLDEVNAME token-type ZSPI-TYP-STRING
ZEMS-TKN-LDEVNUMBER token-type ZSPI-TYP-INT2
Event-Message Text
$tapenn Device interface error, LDEV $nn