NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-18
Messages
Cause. This function is not supported.
Effect. None.
Recovery. None.
-1029: ZTAP-EVT-DEV-BUSY
A tape drive reported an incomplete command.
Unconditional Tokens
Cause. A command was not completed by the tape drive.
Effect. The command fails.
Recovery. Reissue the command. If the error continues to occur, see Recovery Action
Requiring Vendor Support on page 10-15.
Subject: ZTAP-TKN-LDEVNUMBER
Potentially critical event: Yes
Action event: Yes
Message sender: Tape process
OSM/TSM collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-ENUM
ZEMS-TKN-XLDEVNAME token-type ZSPI-TYP-STRING
ZEMS-TKN-LDEVNUMBER token-type ZSPI-TYP-INT2
Event-Message Text
$tapenn Device busy, LDEV $nn
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-DEV-
BUSY (-1029).
ZEMS-TKN-XLDEVNAME Subject token that specifies the name of the tape device in
the form $nnnn.
ZEMS-TKN-LDEVNUMBER Subject token that specifies the logical device number in
the form $nn.