NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-20
Messages
Unconditional Tokens
Cause. A timeout value is too short or there is a tape drive problem.
Effect. The command fails.
Recovery. Reset the tape drive. If the error continues to occur, see Recovery Action
Requiring Vendor Support on page 10-15.
-1026: ZTAP-EVT-DEV-SEL-TIMEOUT
A tape drive selection operation timed out.
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-ENUM
ZEMS-TKN-XLDEVNAME token-type ZSPI-TYP-STRING
ZEMS-TKN-LDEVNUMBER token-type ZSPI-TYP-INT2
Event-Message Text
$tapenn Device command timeout, LDEV $nn
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-DEV-
CMD-TIMEOUT (-1027).
ZEMS-TKN-XLDEVNAME Subject token that specifies the name of the tape device in
the form $nnnn.
ZEMS-TKN-LDEVNUMBER Subject token that specifies the logical device number in
the form $nn.
Subject: ZTAP-TKN-LDEVNUMBER
Potentially critical event: Yes
Action event: Yes
Message sender: Tape process
OSM/TSM collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-ENUM
ZEMS-TKN-XLDEVNAME token-type ZSPI-TYP-STRING
ZEMS-TKN-LDEVNUMBER token-type ZSPI-TYP-INT2
Event-Message Text
$tapenn Device select timeout, LDEV $nn