NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-27
Messages
Cause. An execute I/O (EIO) was issued, but no interrupt was received for the EIO; a
timeout on the EIO did not occur. The interrupt from the controller never occurred, or
the interrogate I/O (IIO) processing the interrupt failed. A problem exists with the
controller.
Effect. The tape operation aborts.
Recovery. If the error continues to occur, see Recovery Action Requiring Vendor
Support on page 10-15.
-1020: ZTAP-EVT-PON-CMN
A power-on (PON) interrupt occurred.
ZEMS-TKN-MAP-PHYSICAL-
ADDRESS.ZEMS-DDL-
PHYSICAL-ADDRESS.ZPA-
GROUP
Nonshared group token that is reserved for the vendor.
ZEMS-TKN-MAP-PHYSICAL-
ADDRESS.ZEMS-DDL-
PHYSICAL-ADDRESS.ZPA-
MODULE
Nonshared module token that is reserved for the
vendor.
ZEMS-TKN-MAP-PHYSICAL-
ADDRESS.ZEMS-DDL-
PHYSICAL-ADDRESS.ZPA-SLOT
Nonshared slot token that is reserved for the vendor.
ZEMS-TKN-SCSI-TARGET-ID Nonshared token that is reserved for the vendor.
ZEMS-TKN-SCSI-LUN Nonshared token that is reserved for the vendor.
ZEMS-TKN-SERVERNET-FABRIC Nonshared token that is reserved for the vendor.
ZEMS-TKN-SAC-NAME Nonshared token that is reserved for the vendor.
Subject: ZTAP-TKN-DEV-NAME
Potentially critical event: No
Action event: No
Message sender: Tape process
OSM/TSM collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-ENUM
ZTAP-TKN-DEV-NAME token-type ZSPI-TYP-DEVICE
ZEMS-TKN-XLDEVNAME token-type ZSPI-TYP-STRING
ZEMS-TKN-MAP-PHYSICAL-ADDRESS.
ZEMS-DDL-PHYSICAL-ADDRESS.
ZPA-GROUP token-type ZSPI-DDL-INT2
Token Description (page 2 of 2)