NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-32
Messages
Unconditional Tokens
Cause. The state of a path (for example, UP or DOWN) has changed.
Effect. None.
Recovery. This is an informational message only; no corrective action is needed.
ZEMS-TKN-MAP-PHYSICAL-ADDRESS.
ZEMS-DDL-PHYSICAL-ADDRESS.
ZPA-SLOT token-type ZSPI-DDL-INT2
ZTAP-TKN-OLD-PATH-STATE token-type ZXYZ-TYP-PATH-
STATE
ZTAP-TKN-CHANGE-INITIATOR-CMN token-type ZXYZ-DDL-
CHANGE-INITIATOR
Event-Message Text
dev-name PATH STATE CHANGE, LDEV $ldev,
PHYS ADDR: GROUP group,MODULER module, SLOT slot,
NEW STATE state-old,change-initiator, msg-txt
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-
PATH-STATE-CHANGE (-1016).
ZTAP-TKN-DEV-NAME Subject token that specifies the name of the tape
device.
ZEMS-TKN-XLDEVNAME Subject token that specifies the logical device name of
the subsystem process that reports the event.
ZEMS-TKN-MAP-PHYSICAL-
ADDRESS.ZEMS-DDL-
PHYSICAL-ADDRESS.ZPA-
GROUP
Nonshared group token that is reserved for the vendor.
ZEMS-TKN-MAP-PHYSICAL-
ADDRESS.ZEMS-DDL-
PHYSICAL-ADDRESS.ZPA-
MODULE
Nonshared module token that is reserved for the
vendor.
ZEMS-TKN-MAP-PHYSICAL-
ADDRESS.ZEMS-DDL-
PHYSICAL-ADDRESS.ZPA-SLOT
Nonshared slot token that is reserved for the vendor.
ZTAP-TKN-OLD-PATH-STATE Previous state of the path.
ZTAP-TKN-CHANGE-INITIATOR-
CMN
Internal operator message.