NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-34
Messages
Cause. A processor switch occurred (the backup processor took over as the primary
processor).
Effect. None.
Recovery. If the processor switch occurred as a result of a command (for example,
the SCF PRIMARY DISK command), then no corrective action is needed.
If the error continues to occur, see Recovery Action Requiring Vendor Support on
page 10-15.
-1014: ZTAP-EVT-RECOVERY-COMPLETION
A sense key reported an error recovery.
ZEMS-TKN-MAP-PHYSICAL-
ADDRESS.ZEMS-DDL-
PHYSICAL-ADDRESS.ZPA-
MODULE
Nonshared module token that is reserved for the vendor.
ZEMS-TKN-MAP-PHYSICAL-
ADDRESS.ZEMS-DDL-
PHYSICAL-ADDRESS.ZPA-
SLOT
Nonshared slot token that is reserved for the vendor.
ZTAP-TKN-OLD-CPU Processor number of the processor that the I/O process
was running on before the switch.
ZTAP-TKN-CHANGE-
INITIATOR-CMN
Internal operator message.
Subject: ZTAP-TKN-LDEVNUMBER
Potentially critical event: No
Action event: No
Message sender: Tape process
OSM/TSM collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-ENUM
ZEMS-TKN-XLDEVNAME token-type ZSPI-TYP-STRING
ZEMS-TKN-LDEVNUMBER token-type ZSPI-TYP-INT2
Event-Message Text
$tapenn Sense Key: Recovered Error, LDEV $nn
Token Description (page2of2)