NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-52
Messages
Cause. There is a coding error in the module driver.
Effect. The command operation fails.
Recovery. If the error continues to occur, see Recovery Action Requiring Vendor
Support on page 10-15.
99: ZTAP-EVT-SYN-MD-CONFIG-ERR
A module driver configuration error occurred.
Unconditional Tokens
Cause. There is a module driver configuration error.
Effect. The command operation fails.
Recovery. If the error continues to occur, see Recovery Action Requiring Vendor
Support on page 10-15.
Subject: ZEMS-TKN-LDEVNUMBER
Potentially critical event: Yes
Action event: Yes
Message sender: Tape process
OSM/TSM collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-ENUM
ZEMS-TKN-XLDEVNAME token-type ZSPI-TYP-STRING
ZEMS-TKN-LDEVNUMBER token-type ZSPI-TYP-INT2
Event-Message Text
$tapenn SMD config err, LDEV $nn
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-SYN-
MD-CONFIG-ERR (99).
ZEMS-TKN-XLDEVNAME Subject token that specifies the name of the tape device in
the form $nnnn.
ZEMS-TKN-LDEVNUMBER Subject token that specifies the logical device number in
the form $nn.