NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-54
Messages
Cause. The tape media or tape drive failed. An EIO instruction was issued and the
TERMSTAT returned indicates that the tape write operation was retried. The
TERMSTAT values are:
Effect. If the retry is successful, the write operation finishes.
Recovery. Check the tape media or tape drive. If this event occurs frequently, replace
the tape being used, because it is probably of marginal quality.
If this event occurs frequently on several different tapes, this error could indicate a
problem with the tape drive or controller. If the error continues to occur, see Recovery
Action Requiring Vendor Support on page 10-15.
101: ZTAP-EVT-READ-RETRIED
A tape read operation was retried.
Controller TERMSTAT
3206 36
3207 36
3208 36
3209 36
3211 36
3214 36
3215 (No event)
3681 36
Subject: ZTAP-TKN-DEV-NAME
Potentially critical event: No
Action event: No
Message sender: Tape process
TMDS collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZTAP-TKN-DEV-NAME token-type ZSPI-TYP-DEVICE
ZTAP-TKN-DETECTOR-PROCESS token-type ZSPI-TYP-UINT
ZTAP-TKN-DETECTOR-REV token-type ZSPI-TYP-BYTE-PAIR
ZTAP-TKN-CPU token-type ZSPI-TYP-UINT
ZTAP-TKN-PIN token-type ZSPI-TYP-UINT
ZTAP-TKN-LDEV token-type ZSPI-TYP-UINT
ZTAP-TKN-DEV-TYPE token-type ZSPI-TYP-BYTE-PAIR
ZTAP-TKN-UNIT-ADR token-type ZSPI-TYP-UINT
ZTAP-TKN-CNTLR-SHARED token-type ZSPI-TYP-BOOLEAN
ZTAP-TKN-EIO-LAC token-type ZSPI-TYP-UINT