NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-58
Messages
Unconditional Tokens
Cause. A 3202 controller successfully retried a tape read operation.
The tape media or tape drive failed. The read operation is retried up to 40 times it is
successful or a nonretryable error occurs. If the retry is successful, this message is
generated; if not, some other message is generated. The retryable error conditions are
overrun, parity error, and CRC error. This message could indicate an intermittent
problem with the channel, controller, drive, or tape media.
Effect. None.
Recovery. If the error continues to occur, see Recovery Action Requiring Vendor
Support on page 10-15.
104: ZTAP-EVT-3202-WFM-RETRIED
A 3202 controller successfully retried a tape write-file-mark operation.
Event-Message Text
dev-name READ RETRIED, LDEV $ldev,
SUBCHANNEL ADDRESS %unit-addr, NUMBER OF RETRIES retry-cnt
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-3202-
READ-RETRIED (103).
ZTAP-TKN-DEV-NAME Subject token that specifies the name of the tape device in
the form $nnnn.
Subject: ZTAP-TKN-DEV-NAME
Potentially critical event: No
Action event: No
Message sender: Tape process
TMDS collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZTAP-TKN-DEV-NAME token-type ZSPI-TYP-DEVICE
ZTAP-TKN-DETECTOR-PROCESS token-type ZSPI-TYP-UINT
ZTAP-TKN-DETECTOR-REV token-type ZSPI-TYP-BYTE-PAIR
ZTAP-TKN-CPU token-type ZSPI-TYP-UINT
ZTAP-TKN-PIN token-type ZSPI-TYP-UINT
ZTAP-TKN-LDEV token-type ZSPI-TYP-UINT
ZTAP-TKN-DEV-TYPE token-type ZSPI-TYP-BYTE-PAIR
ZTAP-TKN-UNIT-ADR token-type ZSPI-TYP-UINT