NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-68
Messages
192: ZTAP-EVT-SYN-DEV-SEL-TIMEOUT
A tape device could not be selected.
Unconditional Tokens
Cause. A tape device controller or a tape device error occurs.
Effect. The tape device cannot be selected.
Recovery. Reinsert the controller board or power off and then power on the tape
drive. If the error continues to occur, see Recovery Action Requiring Vendor Support
on page 10-15.
193: ZTAP-EVT-SYN-DEV-CMD-TIMEOUT
A command operation to a tape device timed out.
Subject: ZEMS-TKN-LDEVNUMBER
Potentially critical event: Yes
Action event: Yes
Message sender: Tape process
OSM/TSM collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-ENUM
ZEMS-TKN-XLDEVNAME token-type ZSPI-TYP-STRING
ZEMS-TKN-LDEVNUMBER token-type ZSPI-TYP-INT2
Event-Message Text
$tapenn SMD device selection timeout, LDEV $nn
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-SYN-
DEV-SEL-TIMEOUT (192).
ZEMS-TKN-XLDEVNAME Subject token that specifies the name of the tape device in
the form $nnnn.
ZEMS-TKN-LDEVNUMBER Subject token that specifies the logical device number in
the form $nn.
Subject: ZEMS-TKN-LDEVNUMBER
Potentially critical event: Yes
Action event: Yes
Message sender: Tape process
OSM/TSM collector: Yes