NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-73
Messages
Unconditional Tokens
Cause. A tape drive was reset by the controller because a command operation was
aborted.
Effect. The command operation fails.
Recovery. None.
199: ZTAP-EVT-SYN-DATA-OVERRUN
A tape device requested more data than the I/O process sent.
Unconditional Tokens
Cause. A tape drive or code problem occurs.
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-SYN-
DEV-RESET (198).
ZEMS-TKN-XLDEVNAME Subject token that specifies the name of the tape device in
the form $nnnn.
ZEMS-TKN-LDEVNUMBER Subject token that specifies the logical device number in
the form $nn.
Subject: ZEMS-TKN-LDEVNUMBER
Potentially critical event: No
Action event: No
Message sender: Tape process
OSM/TSM collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-ENUM
ZEMS-TKN-XLDEVNAME token-type ZSPI-TYP-STRING
ZEMS-TKN-LDEVNUMBER token-type ZSPI-TYP-INT2
Event-Message Text
$tapenn SMD device data overrun, LDEV $nn
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-SYN-
DATA-OVERRUN (199).
ZEMS-TKN-XLDEVNAME Subject token that specifies the name of the tape device in
the form $nnnn.
ZEMS-TKN-LDEVNUMBER Subject token that specifies the logical device number in
the form $nn.