NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-75
Messages
Unconditional Tokens
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-BAD-
UCODE (200).
ZTAP-TKN-DEV-NAME Subject token that specifies the name of the tape device in
the form $nnnn.
ZTAP-TKN-DL-UCODE-ERR Microcode download error code (see Table 10-9
on
page 10-75).
Table 10-9. ZTAP-TKN-DL-UCODE-ERR Values
Symbolic Name (ZTAP-VAL-)
Numeric
Value Description
DLU-OK 0 The download was successful.
DLU-NO-BUF 1 No buffer pool space was available.
DLU-RESET 2 A reset-controller error occurred.
DLU-ID-DEV 3 An identify-device error occurred.
DLU-OPEN 4 An error occurred on an attempt to open the
microcode file.
DLU-DIR-READ 5
An error occurred on an attempt to
read the microcode file directory
.
DLU-DIR-SEARCH 6 An error occurred on an attempt to search
the microcode file directory.
DLU-READ 7 An error occurred on an attempt to read the
microcode file.
DLU-LOAD-LOCS 8 A LOAD LOCS error occurred.
DLU-LOAD-SEX 9 A start-execution error occurred.
DLU-SET-DEN 10 A set-density error occurred.
DLU-SELF-TEST 11 A controller-selftest error occurred.
DLU-GENR-ERR 12 A device-generation error occurred.
DLU-GENR-FILE-TYPE 13 An incorrect microcode file type was
detected.
DLU-FILE-ACCESS 14 An access error occurred on the microcode
file.
DLU-UND-ERR -1 An undetermined error occurred on a
microcode download.