NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-83
Messages
Cause. An EIO instruction was issued, and the TERMSTAT returned indicates that a
hard self-test error occurred. Depending on the particular TERMSTAT value, this event
message indicates a problem with the controller. The TERMSTAT values are:
Effect. The tape operation aborts.
Recovery. If the error continues to occur, see Recovery Action Requiring Vendor
Support on page 10-15.
206: ZTAP-EVT-ILLEGAL-COMMAND
An illegal command was sent to a controller.
Controller TERMSTAT
3206 86 through 91
3207 87 through 92
3208 (No event)
3209 (No event)
3211 125, 126
3214 125, 126
3215 (No event)
3681 125, 126, 206
Subject: ZTAP-TKN-DEV-NAME
Potentially critical event: Yes
Action event: No
Message sender: Tape process
TMDS collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZTAP-TKN-DEV-NAME token-type ZSPI-TYP-DEVICE
ZTAP-TKN-DETECTOR-PROCESS token-type ZSPI-TYP-UINT
ZTAP-TKN-DETECTOR-REV token-type ZSPI-TYP-BYTE-PAIR
ZTAP-TKN-CPU token-type ZSPI-TYP-UINT
ZTAP-TKN-PIN token-type ZSPI-TYP-UINT
ZTAP-TKN-LDEV token-type ZSPI-TYP-UINT
ZTAP-TKN-DEV-TYPE token-type ZSPI-TYP-BYTE-PAIR
ZTAP-TKN-UNIT-ADR token-type ZSPI-TYP-UINT
ZEMS-MAP-EXIOADDR token-type ZSPI-DDL-EXIOADDR
ZTAP-TKN-CNTLR-SHARED token-type ZSPI-TYP-BOOLEAN
ZTAP-TKN-EIO-LAC token-type ZSPI-TYP-UINT