NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-84
Messages
Unconditional Tokens
Cause. A controller received an illegal command. This event can occur when the
controller has run out of PROM code and a downloaded command is sent. Check the
unloaded bit in the RDST word. If this bit is set to 1, then the next event for this
controller must be a UCODE-DOWNLOAD. If the unloaded bit is zero, there might be a
problem in the controller, cabling, or channel.
An EIO instruction was issued, and the TERMSTAT returned indicates that an illegal
command was sent to the controller. The TERMSTAT values are:
Effect. The tape operation aborts.
Recovery. If the error continues to occur, see Recovery Action Requiring Vendor
Support on page 10-15.
ZTAP-TKN-EIO-LPRM token-type ZSPI-TYP-UINT
ZTAP-TKN-EIO-RDST token-type ZSPI-TYP-UINT
ZTAP-TKN-EIO-CHANSTAT token-type ZSPI-TYP-UINT
ZTAP-TKN-IIO-RIC token-type ZSPI-TYP-UINT
ZTAP-TKN-IIO-RIST token-type ZSPI-TYP-UINT
ZTAP-TKN-IIO-CHANSTAT token-type ZSPI-TYP-UINT
ZTAP-TKN-IOC-COUNT token-type ZSPI-TYP-UINT
ZTAP-TKN-IOC-RESIDUE token-type ZSPI-TYP-UINT
Event-Message Text
dev-name ILLEGAL COMMAND ERROR, LDEV $ldev,
SUBCHANNEL ADDRESS %unit-addr
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-
ILLEGAL-COMMAND (206).
ZTAP-TKN-DEV-NAME Subject token that specifies the name of the tape device in
the form $nnnn.
Controller TERMSTAT
3206 44
3207 47
3208 47
3209 47
3211 48, 50
3214 48, 50, 51, 58
3215 48, 50
3681 48