NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-86
Messages
Cause. An EIO instruction was issued, and the TERMSTAT returned indicates that the
NVRAM checksum is incorrect. Either the data written into the NVRAM is invalid, or the
controller is incorrectly calculating the checksum. The TERMSTAT values are:
Effect. The tape operation aborts.
Recovery. If the error continues to occur, see Recovery Action Requiring Vendor
Support on page 10-15.
208: ZTAP-EVT-NVRAM-1000
A NVRAM was written more than 1000 times.
Controller TERMSTAT
3206 (No event)
3207 46
3208 46
3209 46
3211 (No event)
3214 (No event)
3215 (No event)
3681 (No event)
Subject: ZTAP-TKN-DEV-NAME
Potentially critical event: No
Action event: No
Message sender: Tape process
TMDS collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZTAP-TKN-DEV-NAME token-type ZSPI-TYP-DEVICE
ZTAP-TKN-DETECTOR-PROCESS token-type ZSPI-TYP-UINT
ZTAP-TKN-DETECTOR-REV token-type ZSPI-TYP-BYTE-PAIR
ZTAP-TKN-CPU token-type ZSPI-TYP-UINT
ZTAP-TKN-PIN token-type ZSPI-TYP-UINT
ZTAP-TKN-LDEV token-type ZSPI-TYP-UINT
ZTAP-TKN-DEV-TYPE token-type ZSPI-TYP-BYTE-PAIR
ZTAP-TKN-UNIT-ADR token-type ZSPI-TYP-UINT
ZEMS-MAP-EXIOADDR token-type ZSPI-DDL-EXIOADDR
ZTAP-TKN-CNTLR-SHARED token-type ZSPI-TYP-BOOLEAN
ZTAP-TKN-EIO-LAC token-type ZSPI-TYP-UINT