NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-90
Messages
Unconditional Tokens
Cause. The controller is not available or has caused too many interrupts.
Effect. The path to the tape device is lost.
Recovery. Check the controller hardware. If the error continues to occur, see
Recovery Action Requiring Vendor Support on page 10-15.
257: ZTAP-EVT-SYN-CTLR-ACC-NOT-ESTB
Controller access from a processor could not be established.
Unconditional Tokens
Cause. A processors’s initial attempt to access the controller caused an error.
Effect. None.
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-SYN-
CTRL-DISABLED (256).
ZEMS-TKN-XLDEVNAME Subject token that specifies the name of the tape device in
the form $nnnn.
ZEMS-TKN-LDEVNUMBER Subject token that specifies the logical device number in
the form $nn.
Subject: ZEMS-TKN-LDEVNUMBER
Potentially critical event: No
Action event: No
Message sender: Tape process
OSM/TSM collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-ENUM
ZEMS-TKN-XLDEVNAME token-type ZSPI-TYP-STRING
ZEMS-TKN-LDEVNUMBER token-type ZSPI-TYP-INT2
Event-Message Text
$tapenn SMD controller access not established, LDEV $nn
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-SYN-
CTRL-ACC-NOT-ESTB (257).
ZEMS-TKN-XLDEVNAME Subject token that specifies the name of the tape device in
the form $nnnn.
ZEMS-TKN-LDEVNUMBER Logical device number in the form $nn.