NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-94
Messages
Effect. The path is lost.
Recovery. Check the controller hardware. Reset the controller, if necessary. In the
event of a controller failure, see Recovery Action Requiring Vendor Support on
page 10-15.
288: ZTAP-EVT-SYN-SCSI-BUS-RESET
A SCSI-bus reset was issued by a controller.
Unconditional Tokens
Cause. A SCSI bus becomes nonresponsive (hung) and is rest by its controller.
Effect. The current operation fails.
Recovery. The reset causes the operation to be retried.
Subject: ZEMS-TKN-LDEVNUMBER
Potentially critical event: No
Action event: No
Message sender: Tape process
OSM/TSM collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-ENUM
ZEMS-TKN-XLDEVNAME token-type ZSPI-TYP-STRING
ZEMS-TKN-LDEVNUMBER token-type ZSPI-TYP-INT2
Event-Message Text
$tapenn SMD scsi bus reset, LDEV $nn
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-SYN-
SCSI-BUS-RESET (288).
ZEMS-TKN-XLDEVNAME Subject token that specifies the name of the tape device in
the form $nnnn.
ZEMS-TKN-LDEVNUMBER Subject token that specifies the logical device number in
the form $nn.