NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-98
Messages
Unconditional Tokens
Cause. An EIO instruction was issued, and the TERMSTAT returned indicates that an
uncorrectable data error occurred. Depending on the particular device status value, this
event message can indicate a problem with the media, drive, controller, or channel.
The TERMSTAT values are:
Effect. The tape operation aborts.
Recovery. Check the tape and try it on another drive. If the tape is causing the
problem, replace it. If the error continues to occur, see Recovery Action Requiring
Vendor Support on page 10-15.
302: ZTAP-EVT-D-PATH-PARITY-ERROR
A data-path parity error occurred.
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-DATA-
UNCORRECTED (301).
ZTAP-TKN-DEV-NAME Subject token that specifies the name of the tape device in
the form $nnnn.
Controller TERMSTAT
3206 40
3207 40
3208 40
3209 40
3211 192, 193
3214 192, 193, 227, 228
3215 192, 193, 228
3681 192, 193, 227, 228
Subject: ZTAP-TKN-DEV-NAME
Potentially critical event: Yes
Action event: No
Message sender: Tape process
TMDS collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZTAP-TKN-DEV-NAME token-type ZSPI-TYP-DEVICE
ZTAP-TKN-DETECTOR-PROCESS token-type ZSPI-TYP-UINT
ZTAP-TKN-DETECTOR-REV token-type ZSPI-TYP-BYTE-PAIR
ZTAP-TKN-CPU token-type ZSPI-TYP-UINT