NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-102
Messages
Unconditional Tokens
Cause. An erase EIO instruction was issued to a 3207, 3208, or 3209 controller, and
the TERMSTAT returned indicates that the erase command failed. TERMSTAT values
are:
Depending on the drive status value, this event message can indicate a problem with
the drive, the formatter, the controller, or the channel.
Effect. The tape operation aborts.
Recovery. If the error continues to occur, see Recovery Action Requiring Vendor
Support on page 10-15.
ZTAP-TKN-EIO-CHANSTAT token-type ZSPI-TYP-UINT
ZTAP-TKN-IIO-RIC token-type ZSPI-TYP-UINT
ZTAP-TKN-IIO-RIST token-type ZSPI-TYP-UINT
ZTAP-TKN-IIO-CHANSTAT token-type ZSPI-TYP-UINT
ZTAP-TKN-IOC-COUNT token-type ZSPI-TYP-UINT
ZTAP-TKN-IOC-RESIDUE token-type ZSPI-TYP-UINT
ZTAP-TKN-TAPE-VOLUME token-type ZTAP-TYP-TAPE-VOLUME
ZTAP-TKN-DEV-STATUS token-type ZSPI-TYP-UINT
Event-Message Text
dev-name ERASE FAILED, LDEV $ldev,
SUBCHANNEL ADDRESS %unit-add
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-
ERASE-FAILED (304).
ZTAP-TKN-DEV-NAME Subject token that specifies the name of the tape device in
the form $nnnn.
Controller TERMSTAT
3206 (No event)
3207 44
3208 44
3209 44
3211 (No event)
3214 (No event)
3215 (No event)
3681 (No event)