NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-107
Messages
Cause. An EIO instruction was issued, and the TERMSTAT returned indicates that an
error occurred in the formatter (or formatter module for the 3207 controller). Depending
on the drive status value, this event message can indicate a problem with the drive,
formatter, or controller. TERMSTAT values are:
Effect. The tape operation aborts.
Recovery. If the error continues to occur, see Recovery Action Requiring Vendor
Support on page 10-15.
308: ZTAP-EVT-ILLEGAL-DRIVE-STATUS
An illegal drive status was detected.
Controller TERMSTAT
3206 (No event)
3207 55
3208 55
3209 (No event)
3211 (No event)
3214 (No event)
3215 (No event)
3681 (No event)
Subject: ZTAP-TKN-DEV-NAME
Potentially critical event: Yes
Action event: No
Message sender: Tape process
TMDS collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZTAP-TKN-DEV-NAME token-type ZSPI-TYP-DEVICE
ZTAP-TKN-DETECTOR-PROCESS token-type ZSPI-TYP-UINT
ZTAP-TKN-DETECTOR-REV token-type ZSPI-TYP-BYTE-PAIR
ZTAP-TKN-CPU token-type ZSPI-TYP-UINT
ZTAP-TKN-PIN token-type ZSPI-TYP-UINT
ZTAP-TKN-LDEV token-type ZSPI-TYP-UINT
ZTAP-TKN-DEV-TYPE token-type ZSPI-TYP-BYTE-PAIR
ZTAP-TKN-UNIT-ADR token-type ZSPI-TYP-UINT
ZEMS-MAP-EXIOADDR token-type ZSPI-DDL-EXIOADDR
ZTAP-TKN-CNTLR-SHARED token-type ZSPI-TYP-BOOLEAN
ZTAP-TKN-EIO-LAC token-type ZSPI-TYP-UINT
ZTAP-TKN-EIO-LPRM token-type ZSPI-TYP-UINT
ZTAP-TKN-EIO-RDST token-type ZSPI-TYP-UINT