NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-111
Messages
Unconditional Tokens
Cause. An EIO instruction was issued, and the TERMSTAT returned indicates that the
operation failed. Depending on the drive status value, this event message can indicate
a problem with the drive, formatter, controller, or channel. The TERMSTAT values are:
The probable cause is ID-burst noise in the record. If a tape read operation failed, the
problem might be caused by the tape drive that wrote the tape.
Effect. The tape operation aborts.
Recovery. If the error continues to occur, see Recovery Action Requiring Vendor
Support on page 10-15.
ZTAP-TKN-EIO-CHANSTAT token-type ZSPI-TYP-UINT
ZTAP-TKN-IIO-RIC token-type ZSPI-TYP-UINT
ZTAP-TKN-IIO-RIST token-type ZSPI-TYP-UINT
ZTAP-TKN-IIO-CHANSTAT token-type ZSPI-TYP-UINT
ZTAP-TKN-IOC-COUNT token-type ZSPI-TYP-UINT
ZTAP-TKN-IOC-RESIDUE token-type ZSPI-TYP-UINT
ZTAP-TKN-TAPE-VOLUME token-type ZTAP-TYP-TAPE-VOLUME
ZTAP-TKN-DEV-STATUS token-type ZSPI-TYP-UINT
Event-Message Text
dev-name OPERATION FAILED, LDEV $ldev,
SUBCHANNEL ADDRESS %unit-addr
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-
OPERATION-FAILED (310).
ZTAP-TKN-DEV-NAME Subject token that specifies the name of the tape device in
the form $nnnn.
Controller TERMSTAT
3206 42
3207 42
3208 42
3209 42
3211 (No event)
3214 (No event)
3215 (No event)
3681 (No event)