NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-117
Messages
Unconditional Tokens
Cause. An EIO instruction was issued, and the TERMSTAT returned has a value
greater than 39, which is not defined by any other events. This event message can
indicate a problem with the drive, formatter, controller, or channel.
Effect. The tape operation aborts.
Recovery. If the software is up-to-date, it must recognize all TERMSTAT values
returned by the different controllers. Look for a hardware problem in the controller,
controller microcode, or channel. If the error continues to occur, see Recovery Action
Requiring Vendor Support on page 10-15.
315: ZTAP-EVT-WRITE-FAILED
A write operation failed.
ZTAP-TKN-EIO-LPRM token-type ZSPI-TYP-UINT
ZTAP-TKN-EIO-RDST token-type ZSPI-TYP-UINT
ZTAP-TKN-EIO-CHANSTAT token-type ZSPI-TYP-UINT
ZTAP-TKN-IIO-RIC token-type ZSPI-TYP-UINT
ZTAP-TKN-IIO-RIST token-type ZSPI-TYP-UINT
ZTAP-TKN-IIO-CHANSTAT token-type ZSPI-TYP-UINT
ZTAP-TKN-IOC-COUNT token-type ZSPI-TYP-UINT
ZTAP-TKN-IOC-RESIDUE token-type ZSPI-TYP-UINT
Event-Message Text
dev-name UNKNOWN RIC TERMSTAT, LDEV $ldev,
SUBCHANNEL ADDRESS %unit-addr
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-
TERMSTAT-UNKNOWN (314).
ZTAP-TKN-DEV-NAME Subject token that specifies the name of the tape device in
the form $nnnn.
Subject: ZTAP-TKN-DEV-NAME
Potentially critical event: Yes
Action event: No
Message sender: Tape process
TMDS collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZTAP-TKN-DEV-NAME token-type ZSPI-TYP-DEVICE
ZTAP-TKN-DETECTOR-PROCESS token-type ZSPI-TYP-UINT