NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-120
Messages
Unconditional Tokens
Cause. An EIO instruction was issued, and the TERMSTAT returned indicates that the
cable is not connected or is broken. Depending on the device status value, this event
message can indicate a problem with the drive, controller, or cable. The TERMSTAT
values are:
Effect. The tape operation aborts.
Recovery. Ensure that the cable between the tape drive and the controller is
connected. If the error continues to occur, see Recovery Action Requiring Vendor
Support on page 10-15.
317: ZTAP-EVT-CONTROLLER-DATA-ERROR
A controller data error occurred.
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-
CABLE-OPEN (316).
ZTAP-TKN-DEV-NAME Subject token that specifies the name of the tape device in
the form $nnnn.
Controller TERMSTAT
3206 (No event)
3207 (No event)
3208 (No event)
3209 60
3211 170, 171
3214 170, 171
3215 171
3681 170, 171
Subject: ZTAP-TKN-DEV-NAME
Potentially critical event: Yes
Action event: No
Message sender: Tape process
TMDS collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZTAP-TKN-DEV-NAME token-type ZSPI-TYP-DEVICE
ZTAP-TKN-DETECTOR-PROCESS token-type ZSPI-TYP-UINT
ZTAP-TKN-DETECTOR-REV token-type ZSPI-TYP-BYTE-PAIR