NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-123
Messages
Unconditional Tokens
Cause. An EIO instruction was issued, and the TERMSTAT returned indicates that the
physical EOT was encountered on a 3209 controller. This event message usually
indicates a software error or a problem with the tape drive. The TERMSTAT values are:
Effect. The tape operation aborts.
Recovery. Ensure that the operation does not try to write beyond the EOT marker. If
the error is not a software error, contact your service provider.
319: ZTAP-EVT-DEVICE-INTF-ERROR
A communication error occurred between a 3209 controller and a 5120 tape drive.
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-
PHYSICAL-EOT (318).
ZTAP-TKN-DEV-NAME Subject token that specifies the name of the tape device in
the form $nnnn.
Controller TERMSTAT
3206 (No event)
3207 (No event)
3208 (No event)
3209 57
3211 (No event)
3214 (No event)
3215 57
3681 (No event)
Subject: ZTAP-TKN-DEV-NAME
Potentially critical event: Yes
Action event: No
Message sender: Tape process
TMDS collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZTAP-TKN-DEV-NAME token-type ZSPI-TYP-DEVICE
ZTAP-TKN-DETECTOR-PROCESS token-type ZSPI-TYP-UINT
ZTAP-TKN-DETECTOR-REV token-type ZSPI-TYP-BYTE-PAIR
ZTAP-TKN-CPU token-type ZSPI-TYP-UINT