NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-132
Messages
Unconditional Tokens
Cause. The RIC word from an I/O operation on a 3202 controller has the data parity
error flag set. A read, write, or write-file-mark operation that receives this error is retried
up to 40 times. The controller sets this flag when it detects a vertical or longitudinal
parity error during a read or during the readback check of a write operation.
This event indicates a problem with the drive or the tape media.
Effect. The operation aborts.
Recovery. If the error continues to occur, see Recovery Action Requiring Vendor
Support on page 10-15.
326: ZTAP-EVT-3202-CRCERROR
A 3202 controller detected a CRC error.
ZTAP-TKN-IIO-CHANSTAT token-type ZSPI-TYP-UINT
ZTAP-TKN-IOC-COUNT token-type ZSPI-TYP-UINT
ZTAP-TKN-IOC-RESIDUE token-type ZSPI-TYP-UINT
ZTAP-TKN-TAPE-VOLUME token-type ZTAP-TYP-TAPE-VOLUME
Event-Message Text
dev-name PARITY ERROR, LDEV $ldev,
SUBCHANNEL ADDRESS %unit-add
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-3202-
PARITY-ERROR (325).
ZTAP-TKN-DEV-NAME Subject token that specifies the name of the tape device in
the form $nnnn.
Subject: ZTAP-TKN-DEV-NAME
Potentially critical event: No
Action event: No
Message sender: Tape process
TMDS collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZTAP-TKN-DEV-NAME token-type ZSPI-TYP-DEVICE
ZTAP-TKN-DETECTOR-PROCESS token-type ZSPI-TYP-UINT
ZTAP-TKN-DETECTOR-REV token-type ZSPI-TYP-BYTE-PAIR
ZTAP-TKN-CPU token-type ZSPI-TYP-UINT
ZTAP-TKN-PIN token-type ZSPI-TYP-UINT
ZTAP-TKN-LDEV token-type ZSPI-TYP-UINT
ZTAP-TKN-DEV-TYPE token-type ZSPI-TYP-BYTE-PAIR