NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-139
Messages
Unconditional Tokens
Cause. A problem exists with a tape. An EIO instruction was issued, and the
TERMSTAT returned indicates that the tape in the drive has an error. The TERMSTAT
values are:
Effect. Depending on the cause of the error, either the tape operation aborts or the
tape is rewound and unloaded.
Recovery. First, ensure that the tape is labeled. Then check the drive to ensure that it
is set at the density recorded on the tape volume. If you don’t know the tape volume
density, try switching to the other density setting.
If the problem is a faulty drive, first clean the drive heads and tape guides and then
retry. If the error continues to occur, see Recovery Action Requiring Vendor Support on
page 10-15.
ZTAP-TKN-IIO-RIC token-type ZSPI-TYP-UINT
ZTAP-TKN-IIO-RIST token-type ZSPI-TYP-UINT
ZTAP-TKN-IIO-CHANSTAT token-type ZSPI-TYP-UINT
ZTAP-TKN-IOC-COUNT token-type ZSPI-TYP-UINT
ZTAP-TKN-IOC-RESIDUE token-type ZSPI-TYP-UINT
Event-Message Text
dev-name ID BURST ERROR, LDEV $ldev,
SUBCHANNEL ADDRESS %unit-addr
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-ID-
BURST-ERROR (331).
ZTAP-TKN-DEV-NAME Subject token that specifies the name of the tape device in
the form $nnnn.
Controller TERMSTAT
3206 (No event)
3207 (No event)
3208 (No event)
3209 (No event)
3211 225
3214 225
3215 225
3681 225