NonStop Operating System Event Management Programming Manual

Low-Level I/O Event Messages (ZGIO)
HP NonStop Operating System Event Management Programming Manual—520372-020
3-2
123: ZGIO-EVT-IIOPADIN Final handshake was missing following an
odd-byte data transfer.
124: ZGIO-EVT-IIOPADINOSTI
A device controller returned an illegal
handshake on the last byte transferred.
125: ZGIO-EVT-IIOPROTECTVIOLATION
A protect violation occurred on a read
transfer.
126: ZGIO-EVT-IIOSTIFAIL
Final handshake on a data transfer was not
acknowledged.
127: ZGIO-EVT-IIOSVIANDSTI
A device returned both a service-in-
handshake (SVI) and a stop-in-handshake
(STI).
128: ZGIO-EVT-IIOUCMEDATA
An UCME was detected during a write data
transfer.
129: ZGIO-EVT-IIOZEROBYTEREAD
A zero-byte count occurred on a read
operation.
130: ZGIO-EVT-IIOZEROBYTEWRITE
A zero-byte count occurred on a write
operation.
131: ZGIO-EVT-INTCCL
An IIO instruction failed with a condition
code less than (CCL).
132: ZGIO-EVT-IOTRACE
An error occurred during an I/O operation.
133: ZGIO-EVT-SCHANLBADCOMMAND
A controller data-transfer command was
not a read or a write.
134: ZGIO-EVT-SCHANLBADSTAT
An undecodable status was returned from
a channel.
135: ZGIO-EVT-SCHANLDEVRECON
A continuous device-reconnect is pending.
136: ZGIO-EVT-SCHANLIOCUCME
An UCME occurred on access to the I/O
control (IOC) table.
137: ZGIO-EVT-SCHANLIOCABSENT
A page was absent from physical memory
on access to the I/O control (IOC) table.
138: ZGIO-EVT-SCHANLRANK0TIMEOUT
A timeout occurred during an attempt to
access a rank 0 controller.
139: ZGIO-EVT-SCHANLRANK1TIMEOUT
A timeout occurred during an attempt to
access a rank 1 controller.
140: ZGIO-EVT-SCHANLRCIERROR
An RCI was sent but no device controller
responded.
141: ZGIO-EVT-SCHANLRPOLLRANK0
An illegal device handshake occurred
during poll of rank 0.
142: ZGIO-EVT-SCHANLRPOLLRANK1
An illegal device handshake occurred
during poll of rank 1.
Table 3-1. Low-Level I/O Event Messages (page 2 of 3)
Event Number and Symbolic Name Description