NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-154
Messages
Cause. The loadable control store microcode of a downloadable controller was
loaded. (A series of LOAD LOCS EIO instructions were executed.)
Effect. This EIO instruction changes the microcode in the loadable control store of the
controller. During normal operations, the controller must not become unloaded.
Frequent execution of this EIO instruction can indicate a hardware problem. Noting the
occurrence of this EIO instruction allows you to keep track of the current state of the
system.
Recovery. This is an informational message only; no corrective action is needed.
406: ZTAP-EVT-PATH-STATE
A path state changed.
DLU-SELF-TEST 11 A controller-selftest error occurred.
DLU-GENR-ERR 12 A device-generation error occurred.
DLU-GENR-FILE-TYPE
13
An incorrect microcode file type was
detected.
DLU-FILE-ACCESS
14
An access error occurred on the
microcode file.
DLU-UND-ERR
-1
An undetermined error occurred on a
microcode download.
Subject: ZTAP-TKN-DEV-NAM
Potentially critical event: No
Action event: No
Message sender: Tape process
TMDS collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZTAP-TKN-DEV-NAME token-type ZSPI-TYP-DEVICE
ZTAP-TKN-DETECTOR-PROCESS token-type ZSPI-TYP-UINT
ZTAP-TKN-DETECTOR-REV token-type ZSPI-TYP-BYTE-PAIR
ZTAP-TKN-CPU token-type ZSPI-TYP-UINT
ZTAP-TKN-PIN token-type ZSPI-TYP-UINT
ZTAP-TKN-LDEV token-type ZSPI-TYP-UINT
ZTAP-TKN-DEV-TYPE token-type ZSPI-TYP-BYTE-PAIR
ZTAP-TKN-UNIT-ADR token-type ZSPI-TYP-UINT
ZEMS-MAP-EXIOADDR token-type ZSPI-DDL-EXIOADDR
ZTAP-TKN-CNTLR-SHARED token-type ZSPI-TYP-BOOLEAN
Table 10-10. ZTAP-TKN-DL-UCODE-ERR Values (page 2 of 2)
Symbolic Name (ZTAP-VAL-)
Numeric
Value Description