NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-155
Messages
Unconditional Tokens
Cause. A path state changed (for example, up or down).
Effect. None.
Recovery. This is an informational message only; no corrective action is needed.
407: ZTAP-EVT-PON
A power-on (PON) interrupt occurred.
ZTAP-TKN-PATH-STATE token-type ZSPI-TYP-UINT
ZTAP-TKN-PATH-STATE-NEW token-type ZSPI-TYP-UINT
ZTAP-TKN-CHANGE-INITIATOR token-type ZSPI-TYP-UINT
Event-Message Text
dev-name PATH STATE CHANGE, LDEV $ldev,
SUBCHANNEL ADDRESS %unit-addr
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-
PATH-STATE (406).
ZTAP-TKN-DEV-NAME Subject token that specifies the name of the tape device in
the form $nnnn.
ZTAP-TKN-PATH-STATE State of the path before the change. Values are:
1. Up
2. Down
ZTAP-TKN-PATH-STATE-NEW State of the path after the change. Values are:
1. Up
2. Down
ZTAP-TKN-CHANGE-
INITIATOR
Indicates the initiator of the change. Values are:
1. The system initiated the change (for example, through
the I/O Process).
2. An operator initiated the change (for example, from a
PUP command).
Subject: ZTAP-TKN-DEV-NAM
Potentially critical event: No
Action event: No
Message sender: Tape process
TMDS collector: Yes