NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-156
Messages
Unconditional Tokens
Cause. A power failure was followed by a power-on (PON) interrupt. The state of the
hardware can be changed by a power failure and a subsequent power on.
Effect. Microcode is reloaded for all downloadable controllers for which the processor
where the power failed was the primary processor.
Recovery. This is an informational message only; no corrective action is needed.
408: ZTAP-EVT-SET-BURST-EIO
A SET BURST EIO instruction was executed.
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZTAP-TKN-DEV-NAME token-type ZSPI-TYP-DEVICE
ZTAP-TKN-DETECTOR-PROCESS token-type ZSPI-TYP-UINT
ZTAP-TKN-DETECTOR-REV token-type ZSPI-TYP-BYTE-PAIR
ZTAP-TKN-CPU token-type ZSPI-TYP-UINT
ZTAP-TKN-PIN token-type ZSPI-TYP-UINT
ZTAP-TKN-LDEV token-type ZSPI-TYP-UINT
ZTAP-TKN-DEV-TYPE token-type ZSPI-TYP-BYTE-PAIR
ZTAP-TKN-UNIT-ADR token-type ZSPI-TYP-UINT
ZEMS-MAP-EXIOADDR token-type ZSPI-DDL-EXIOADDR
ZTAP-TKN-CNTLR-SHARED token-type ZSPI-TYP-BOOLEAN
ZTAP-TKN-PON token-type ZSPI-TYP-UINT
Event-Message Text
dev-name PON INTERRUPT OCCURRED, LDEV $ldev,
SUBCHANNEL ADDRESS %unit-addr
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-PON
(407).
ZTAP-TKN-DEV-NAME Subject token that specifies the name of the tape device in
the form $nnnn.
ZTAP-TKN-PON Type of power on. Decimal values are:

0 [processor power on (PON)]

1 [I/O power on (IOPON)]
Subject: ZTAP-TKN-DEV-NAM
Potentially critical event: No
Action event: No
Message sender: Tape process
TMDS collector: Yes