NonStop Operating System Event Management Programming Manual

Tape Process Event Messages (ZTAP)
HP NonStop Operating System Event Management Programming Manual—520372-020
10-158
Messages
Unconditional Tokens
Cause. A SET HOLDOFF EIO instruction was executed.
Effect. The interface between the channel and the controller is changed.
Recovery. This is an informational message only; no corrective action is needed.
410: ZTAP-EVT-UNEXPECTED-INT
An unexpected interrupt occurred.
ZTAP-TKN-CPU token-type ZSPI-TYP-UINT
ZTAP-TKN-PIN token-type ZSPI-TYP-UINT
ZTAP-TKN-LDEV token-type ZSPI-TYP-UINT
ZTAP-TKN-DEV-TYPE token-type ZSPI-TYP-BYTE-PAIR
ZTAP-TKN-UNIT-ADR token-type ZSPI-TYP-UINT
ZEMS-MAP-EXIOADDR token-type ZSPI-DDL-EXIOADDR
ZTAP-TKN-CNTLR-SHARED token-type ZSPI-TYP-BOOLEAN
ZTAP-TKN-EIO-LPRM token-type ZSPI-TYP-UINT
Event-Message Text
dev-name SET HOLDOFF EIO EXECUTED, LDEV $ldev,
SUBCHANNEL ADDRESS %unit-addr
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZTAP-EVT-SET-
HOLDOFF-EIO (409).
ZTAP-TKN-DEV-NAME Subject token that specifies the name of the tape device in
the form $nnnn.
Subject: ZTAP-TKN-DEV-NAM
Potentially critical event: No
Action event: No
Message sender: Tape process
TMDS collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZTAP-TKN-DEV-NAME token-type ZSPI-TYP-DEVICE
ZTAP-TKN-DETECTOR-PROCESS token-type ZSPI-TYP-UINT
ZTAP-TKN-DETECTOR-REV token-type ZSPI-TYP-BYTE-PAIR
ZTAP-TKN-CPU token-type ZSPI-TYP-UINT
ZTAP-TKN-PIN token-type ZSPI-TYP-UINT
ZTAP-TKN-LDEV token-type ZSPI-TYP-UINT
ZTAP-TKN-DEV-TYPE token-type ZSPI-TYP-BYTE-PAIR
ZTAP-TKN-UNIT-ADR token-type ZSPI-TYP-UINT
ZEMS-MAP-EXIOADDR token-type ZSPI-DDL-EXIOADDR