NonStop Operating System Event Management Programming Manual

Disk Process Event Messages (ZDSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
11-7
5090: ZDSK-EVT-OPER-ABORTED-DUMP A DP2 failure data system (TFDS) data
capture was aborted because of a PUP
UP request
2
or SCF START request
3
.
5091: ZDSK-EVT-DP2-ABORTED-DUMP
A DP2 failure data system (TFDS) data
captured was aborted because of a
takeover.
5093: ZDSK-EVT-SOFTDOWN-STATE
A DP2 processor has entered a
softdown state.
5094: ZDSK-EVT-NO-FLAT-SEGMENTS
DP2 volume initialization failed to
obtain virtual memory space because
of a software incompatibility.
5095: ZDSK-EVT-SMS-FILE-FULL
The number of extents in the specified
file has crossed a user-specified
threshold or interval value for the
number of remaining extents.
5096: ZDSK-EVT-SMS-DISK-FULL
The space available on the disk has
crossed a user-specified threshold or
interval for the amount of remaining
space.
5097: ZDSK-EVT-CHECKPOINT-TIMEOUT
DP2 timed out during an attempt to
checkpoint to the backup DP2
processor.
5099: ZDSK-EVT-INVALID-STATUS
*
An internal error occurred.
5101: ZDSK-EVT-EXCEPT-ERR
*
The syndrome indicates a SCSI
exception error.
5103: ZDSK-EVT-UPGRADE-DONE
*
User initiated an online disk upgrade.
This event is issued after the upgrade
is completed.
5104: ZDSK-EVT-BAD-SUBTYPE
*
The DP2 Driver returned an unknown
or an unexpected subtype value.
5106: ZDSK-EVT-PATH-NOT-OWNED
*
An attempt to revive a disk failed.
5107: ZDSK-EVT-PREDICT-FAIL
*
Some devices support the self-
monitoring analysis and reporting
technology (SMART) feature for
monitoring and storing critical
performance and calibration
information. A device that has the
SMART feature enabled attempted to
report a performance degradation or a
device failure before the problem
occurred, and sent a recovery action
against data loss.
Table 11-1. Disk Process Event Messages (page 7 of 9)
* Generated by the DP2 Driver (T9753)