NonStop Operating System Event Management Programming Manual

Disk Process Event Messages (ZDSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
11-15
Disk Process (ZDSK-) Definitions
Simple Tokens and Structured Tokens
ZDSK-TKN-LACCMD token-type ZSPI-TYP-ENUM
ZDSK-TKN-OPCODE token-type ZSPI-TYP-ENUM
ZDSK-TKN-TERMCODE token-type ZSPI-TYP-ENUM
ZDSK-TKN-VOL-NAME token-type ZSPI-TYP-DEVICE
Token Description
ZDSK-TKN-LACCMD Controller command that the disk process issued (see
Table 11-9
).
ZDSK-TKN-OPCODE Extended controller command that the disk process issued (see
Table 11-10
on page 11-16).
ZDSK-TKN-TERMCODE Termination code (TERMCODE) that the disk controller issued
(see Table 11-11
on page 11-17). TERMCODE corresponds to
bits <1:7> in the RIC.
ZDSK-TKN-VOL-NAME Volume name of the affected disk drive. This token does not
always appear in a disk process event message. If it is present
in an event message, it is an additional subject token.
Table 11-9. ZDSK-TKN-LACCMD Values (page1of2)
Name (ZDSK-VAL-) Description (page1of2)
BOOT-READ Boot read
COLD-LOAD Cold load
FILL-BUFF Fill buffer
FORMAT Format
FORMAT-HEADERS Format headers
IDENTIFY-DEV Identify device
LIST-DEFECTS List defects
LIST-HEADERS List headers
LOAD-LOCS Load LOCS
POST-BUFF Post buffer
READ Read
READ-BUFF Read buffer
READ-FULL-SECTOR Read full sector
READ-LIT-PROM Read unit literal PROM
READ-REGISTERS Read registers
READ-UCODE Read downloadable microcode
READ-WITHOUT-TRANS Read without transfer
RESET-CTLR Reset controller
RESET-UNIT Reset unit