NonStop Operating System Event Management Programming Manual

Disk Process Event Messages (ZDSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
11-17
Disk Process (ZDSK-) Definitions
Table 11-11. ZDSK-TKN-TERMCODE Values (page1of2)
Name (ZDSK-VAL-) Description
ACCESS-ALT-TRACK A direct access to an alternate track occurred.
BAD-CMD-COUNT The command count exceeds 30,720 bytes.
BAD-EIO-PARM An invalid EIO instruction parameter was detected.
BAD-NVRAM An NVRAM was written more than 1000 times and must
be replaced.
BAD-PART-SER-NUM The part and serial number do not compare on an update
revision.
BAD-STRUCT-BLOCK A structured block has an invalid disk process eye-
catcher.
BUFF-PARITY-ERR A buffer parity error occurred.
CTLR-MALFUNCTION A controller experienced a malfunction.
DATA-ERR-CORR A data error was corrected.
DATA-STROBE-EARLY A successful retry occurred.
DATA-STROBE-LATE A successful retry occurred.
DEV-DOWNED A device was brought down by software.
DUP-UNIT-NUM A duplicate unit number was detected.
ECC-ERR-BOOT-RD An ECC error occurred on a boot read.
HDR-ADDR-MISCOMPARE A header address miscompare occurred.
HDR-SEARCH-ERR A header search error occurred.
IBUS-PARITY An I-BUS parity-error read transfer occurred.
ILLEGAL-ADDR An illegal address was detected.
ILLEGAL-OPCODE An illegal opcode was detected.
INTR-OVERRUN An interrupt overrun occurred.
INVALID-ADDR-CNT An invalid address and count were received on a LOAD
LOCS or DEFINE BLOCK command.
INVALID-PARM-ID An invalid parameter was detected for the IDENTIFY
DEVICE command.
INVALID-PARM-UNIT An invalid parameter was detected for the UNIT MASK
command.
NO-ERR No error occurred.
NO-OFFSETS A successful retry of a normal read occurred.
NOT-ENOUGH-DATA Not enough data was received to perform the operation.
OBUS-PARITY An O-BUS parity-error write transfer occurred.
PWR-UP-TST-FAILED A power-up test failed.
ROM-PARITY-ERR The parity on a microinstruction was incorrect.
SELFTST-FAILED A self-test failed.