NonStop Operating System Event Management Programming Manual

Disk Process Event Messages (ZDSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
11-21
Messages
Unconditional Tokens
Conditional Tokens
Cause. The disk completed the last command successfully, after performing some
recovery action.
Effect. None.
Recovery. The valid additional sense code (ASC) will indicate if there is a predictive
failure or if the drive temperature is exceeding the specified limit. Both these ASCs are
a part of the TSM event. This is an informational message only; no corrective action is
needed.
-1001: ZDSK-EVT-SK-NOT-RDY
The disk is not in a ready state and cannot be accessed now.
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message.
Value is ZDSK-EVT-SK-RECVRD-ERR (-1000).
ZEMS-TKN-XLDEVNAME Subject token that specifies the logical device name
of the affected disk drive.
Token Description
ZEMS-TKN-LDEVNUMBER The logical device number of the affected disk drive.
ZDSK-TKN-LOGICAL-PATH-CMN Logical path command of the event.
ZEMS-TKN-SAC-NAME Nonshared token that is reserved for the vendor.
ZEMS-TKN-SCSI-TARGET-ID Nonshared token that is reserved for the vendor.
ZEMS-TKN-SCSI-LUN Nonshared token that is reserved for the vendor.
Subject: ZEMS-TKN-XLDEVNAME
Potentially critical event: No
Action event: No
Message sender: Disk process (ZDSK)
$ZLOG: Yes
$0: No
OSM/TSM collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-XLDEVNAME token-type ZSPI-TYP-STRING